友情连接
The installation of Great Wall H7
发布日期: 2018/3/24 浏览次数: 198

Remove the left lower bracket of the original car, install the left lower bracket of our company and fix it with our screws.

Use the original car ball head, add a gasket below the original car ball head, install our company electrical pole.

Unplug the original vehicle rubber plug and pass the Hall line through this reserved hole. The rubber plug on the card (same as the left and right steps)

Remove the plaque on the side of the main driver and connect the earth wire.

Remove the plaque under the main drive and install the front switch

Unplug this termianal housing at the tailgate. Our Pulse Wire connects to the purple wire of this nest (the first hole in the second row)

Remove the palque on the left side of the trunk and find the switch cable

Switch the two lines thrown off from the switch before the main drive to the front switch cable on the left side of the trunk. The yellow cable is the purple cable and the black cable is the black cable.

Remove the original car lock, install our electric suction lock, use our screws to fix

The motor is mounted on the left side of the boot

Secured with our 3M adhesive

Pull out the vehicle socket at the tailgate lock, insert the three-way socket of our company, and insert the other end of the three-way socket back into the lock

The holzer cable, the power cable, the electric suction plug according to the color of a pair of plug-in control box

Control box installation position, fixed with our screws and gaskets

After the installation is completed, you must set the tailgate

Please make sure the switch is in place.

深圳市明亚科技有限公司 - The installation of Great Wall H7
 
   联系我们  |  销售网络  |   下载中心     
   24小时客服热线:400-705-9608   E-mail:sonls@sonls.com   Tel: 86-755-84419519 / 84419529 转806 / 807   Fax: 86-755-84419316
版权所有:深圳市兴嘉林电子科技有限公司    粤ICP备05089774号    Copyright 2001-2017 All Rights Reserved.