友情连接
The installation of Volkswagen Passat
发布日期: 2018/3/26 浏览次数: 239

Remove the original car spring

Install our ball head, install the electric hole (pictured)

Install the electric hole with the original car bracket

Keep the original car electric pole

Electric hole installation complete diagram

Remove the original car 30A fuse plug, plug our power plug

Earth wire connection

Pull the plug of the original door lock position to the plug of three outlets of our company

Remove the original car lock, install our electric suction lock

Lock the lock rope on the motor, tighten the screws on both sides, and fix it with our screws and washers

Fix it with original motor screws and tighten the screws with a wrench

Connect the plug of our electric suction line with the motor socket

Paste our 3M adhesive on the back of the motor

Motor installation position

The Holzer cable, the power cable, the electric suction cable plug according to the color one pair of inserts the control box

Central control box installation position

After the tailgate trim plate hole installation switch button
After the installation is complete, you must set the tailgate learning. Make sure that the door can be turned on and off.

深圳市明亚科技有限公司 - The installation of Volkswagen Passat
 
   联系我们  |  销售网络  |   下载中心     
   24小时客服热线:400-705-9608   E-mail:sonls@sonls.com   Tel: 86-755-84419519 / 84419529 转806 / 807   Fax: 86-755-84419316
版权所有:深圳市兴嘉林电子科技有限公司    粤ICP备05089774号    Copyright 2001-2017 All Rights Reserved.