友情连接
The installation of BMW
发布日期: 2018/3/26 浏览次数: 109

First remove the boot cover

Remove the three buttons and remove the left panel (same as the left and right steps)

Remove the plastic plaque (same as the left and right steps)

Remove the original car spring, install our company's left bracket and electric pole, add a gasket on the hole of the bracket

Install the head of our electric pole with the original ball head (same as the left and right steps)

Left electric pole installation completed

Remove the button, and our power cord connects to the positive and negative poles of the battery in the trunk, and fixes the harness with a cable tie.

Remove the veneer buckles and warning plate buckles, remove the plaque

Tail door trunk to find the original car electric suction

Unplug the carrier in the original car electric suction and plug the three outlets of our company

The three-way line is routed along the yellow line arrow to the control box and fixed with the cable tie and the original vehicle wire harness

Insert the control rods, power cables, and switch wires as shown in the figure, and stick 3M adhesive on the back of the control box.

The control box is installed on the left side of the battery, fixed with our 3M adhesive, and the harness is fixed with a cable tie.

Loosen the original car lock screw and fine-tune the lock block 2-3mm
Punches the rear door button on the right side of the tailgate

After the installation is complete, you must set the tailgate learning. Make sure that the door can be turned on and off.

深圳市明亚科技有限公司 - The installation of BMW
 
   联系我们  |  销售网络  |   下载中心     
   24小时客服热线:400-705-9608   E-mail:sonls@sonls.com   Tel: 86-755-84419519 / 84419529 转806 / 807   Fax: 86-755-84419316
版权所有:深圳市兴嘉林电子科技有限公司    粤ICP备05089774号    Copyright 2001-2017 All Rights Reserved.