友情连接
The installation of Bisu
发布日期: 2018/3/27 浏览次数: 239

Remove the screws before removing the black cover

Install our company's left upper ball head (the same steps on the left and right sides)

Install our company's left lower bracket and struts (same left and right steps)

Pass the Hall line through the reserved hole on the left and right sides, and insert the rubber plug.

Electric pole installation complete diagram

Holzer cable through the reserved hole and walk to the lock position as shown in the figure

As shown in the picture, remove the cover of the main driving door and remove the screws

As shown in the figure, remove the cover of the door handle and remove the screws to remove the door

After removing the door plaque, the central control line connects the yellow and white lines

The control cable passes through the carriage from the door

Drive power under main drive

The main driver side to find the ground. Ground connection

The central control box is installed in the position shown in the picture, and it is fixed with our washers and screws. The Hall line and the power line are inserted one by one.

Connect the original vehicle unlocking plug with the three-way adapter socket provided by our company. The plug at the other end of our company is inserted into the lock position.Punches holes in the removed tailgate and installs our tailgate button

After the installation is complete, you must set the tailgate learning. Make sure that the door can be turned on and off.

深圳市明亚科技有限公司 - The installation of Bisu
 
   联系我们  |  销售网络  |   下载中心     
   24小时客服热线:400-705-9608   E-mail:sonls@sonls.com   Tel: 86-755-84419519 / 84419529 转806 / 807   Fax: 86-755-84419316
版权所有:深圳市兴嘉林电子科技有限公司    粤ICP备05089774号    Copyright 2001-2017 All Rights Reserved.