友情连接
The installation of Kuga
发布日期: 2018/4/8 浏览次数: 231

Remove the original car struts, use the original car bracket to install the struts (left and right steps the same)

The Hall line passes through this hole (same as the left and right steps)

Remove the plaque on the right side of the trunk and find the power supply

Unplug the original car fuse plug, plug our power plug

Ground wire connection

Remove the trim plate from the side of the main driver, punch and install the front switch button of our company

The two lines thrown by the front switch connect the two lines of the trunk

Unplug the seat at the tailgate lock and insert the three-way socket

Control box installation position, use our company's matching screws and gaskets to fix the plug according to the color of a pair of plug-in control box

The Hall line, the power line, and the electric wire plug according to the color of a pair of plug-in control box

Remove the original car lock, install our electric suction lock, under the electric suction lock pad a square gasket with our company, use our screws to fix the lock

Lock the lock rope on the motor, tighten the screws on both sides, and fix it with our screws and washers

Motor is mounted on the right side of the trunk

Connect the plug of our electric suction line with the motor socket

As shown in the figure at the end of the door trim hole installation of our company tailgate switch button
After the installation is complete, you must set the tailgate learning. Make sure that the door can be turned on and off.

 

深圳市明亚科技有限公司 - The installation of Kuga
 
   联系我们  |  销售网络  |   下载中心     
   24小时客服热线:400-705-9608   E-mail:sonls@sonls.com   Tel: 86-755-84419519 / 84419529 转806 / 807   Fax: 86-755-84419316
版权所有:深圳市兴嘉林电子科技有限公司    粤ICP备05089774号    Copyright 2001-2017 All Rights Reserved.